Dimondek® 400
For Designer, Metallic and Gloss colours, download the ColorCote® special colours brochure.
412mm sheet
Light commercial
Hamilton
Wellington
Christchurch
Dimondek® 400 Performance
Dimondek® 400 adds architectural interest to your roof, with its broad angular ribs and wide pans it brings modern styling to your roof. The concealed fix system provides a strong clean finish with no visible fixings. Ideally suited for modern contemporary homes, DD400 is the ultimate bold statement in roofs.
All dimensions given are nominal
Sheet Tolerances
Sheet width: ±5mm
Sheet length: +10mm, –0mm. For horizontal wall cladding where notified at time of order of intended use, tighter tolerances can be achieved +3mm, –0mm.
*Dimondek 400 is available in Copper ex Auckland only, subject to coil availability.
**To achieve a high level of appearance on the completed roof, it is important that the purlin layout alignment is laid within the tolerances as stated in Section 2.4.2.3.1.
(1) Recommended maximum purlin spacing at minimum radius
(2) Based on 1.1kN point load support, but not intended for roof access.
(3) Product only available in ColorCote® MagnaFlow™ or Colorsteel® MAXX coated product range
n/a – not available
Roll-forming facilities for Dimondek® 400 at: Auckland, Hamilton, Wellington and Christchurch.
Sheet lengths: DD400 is custom run to order.
Where long sheets are used consideration must be given to:
- Special transportation licences for sheet lengths over 25m
- Site access for special lifting equipment
- Fixing techniques to accommodate thermal expansion. Refer Section 2.1.3.4. in Technical Manual
