1. Shake contents before use.

2. Apply New Timber Prep generously undiluted to the timber surface with Cabot's Deck Prep brush. Do not spot clean.

NOTE: New Timber Prep is very slippery. Take care when walking on treated surface. 3. Leave new timber prep on the timber for 10-15 minutes. If necessary, apply more New Timber Prep to keep timber damp during this 10-15 minute period. Do not allow New Timber Prep to dry on the surface.

4. Scrub the surface with Cabot's Deck Prep brush. Do not use a wire brush.

5. Rinse off timber surface with a garden hose or power washer, use the lowest setting to avoid damaging the timber. NOTE: Ensure New Timber Prep is fully washed from the surface as failure to do so may result in timber discolouration under transparent or semi-transparent finishes.

6. While timber is still damp, clean timber with Cabot's Deck Clean following label instructions.

Always use Deck Clean after New Timber Prep.