Note: Fill nail holes, cracks and other defects with Cabot's Wood Tone Putty after applying the first coat of this product for accurate colour matching. Remove stains, dirt, wax, grease and oil with mineral turpentine. Remove any polish with a suitable polish remover.

NOTE: Previously coated interior timber with highly visible scratches, imperfections or surfaces that are severely worn must be sanded prior to coating.

Bare Timber

Sand the surface smooth using 180 - 240 grit sandpaper. Sand only in the direction of the grain. Remove all traces of sanding dust.

Previously Coated Timber

Remove back to bare timber using a paint stripper or sanding. Remove all traces of sanding dust.

Note: Do not shake can.

1. Stir thoroughly with a broad flat paddle before and during use.

2. Apply a full even coat with a brush, roller or rag.

3. Allow to dry for 8 hours.

4. Lightly sand between coats with 240 grit paper. Remove all traces of sanding dust.

5. Apply a 2nd coat as above.

Note - For a higher sheen, apply further coats of Danish Oil as required allowing 8 hours between coats. Sand lightly between coats with 240 grit paper.